Most of the electrical work we do in Jupiter falls into two groups. On one side are the 1970s and 1980s houses around Center Street and Toney Penna Drive, where the wiring is sound but the panel and the grounding belong to a much older code cycle. On the other side is Abacoa and the newer construction south of Indiantown Road, where nothing is broken but the service was sized before anyone in the driveway owned an EV. Our shop is on Jupiter Park Lane. Call (561) 462-2800.
Licensed Electricians Based in Jupiter, FL
Panels, generators, pool and dock circuits, storm repairs, and code corrections from Jupiter Farms to the inlet. Florida Electrical Contractor License EC13015487.
Jupiter Neighborhoods, and What Each One Asks For
- Abacoa: late-1990s through 2010s construction. Capacity and lighting, not repair: EV circuits, surge protection, and recessed housings never designed around the LED trims going into them now.
- Jupiter Farms: acre-plus lots west of the Turnpike where one service feeds the house, a shop, a well pump, sometimes a barn. Long underground runs, sub-panels, and voltage drop, and the permit goes through Palm Beach County rather than the Town of Jupiter.
- Jupiter Inlet Colony and the barrier island: constant salt load. Meter cans, service masts, disconnects, and condenser whips corrode from the outside in.
- Loxahatchee River and Intracoastal waterfront: docks, boat lifts, davits, and pier lighting, all wet-location work under NEC Article 555.
- Center Street and Toney Penna Drive: 1970s and 1980s single-story homes carrying panels Florida insurers now ask about by brand name.
- Tequesta and the north end: similar housing stock, different building department, same salt.
- Admirals Cove, Jonathan’s Landing, and the gated communities: association review sits on top of the municipal process, so the paperwork gets planned before the truck rolls.
The Panel Question in 1970s and 1980s Homes
Florida insurers ask for a four-point inspection once a home passes roughly thirty years, and the electrical page is where those reports stall. Federal Pacific Stab-Lok, Zinsco, and Challenger panels come back circled, along with double-tapped breakers, corroded ground rods, and 60-amp services that were fine in 1978 and are not fine with a modern air handler. An electrical panel upgrade is the usual answer, and it brings company: replaced services now require whole-house surge protection under NEC Section 230.67, grounding electrodes get corrected rather than grandfathered, and AFCI and GFCI protection follows the circuits that require it. An electrical safety inspection puts your house in writing before an insurer does.
Aluminum branch wiring, and what actually needs fixing
Homes built here between roughly 1965 and 1973 may have solid aluminum on 15- and 20-amp branch circuits. The failure mode is at the terminations, not mid-wire: warm cover plates, lights that dim when a load kicks on, scorching behind a receptacle. Remediation usually means listed connectors at every device and splice rather than opening walls. And the part that gets lost in the panic: aluminum service-entrance conductors and feeders to a range, dryer, or sub-panel are ordinary and current. When house rewiring genuinely is the better answer, we will show you why.
Salt Air Is a Maintenance Item, Not a Surprise
East of the Intracoastal, outdoor equipment fails in a reliable order: weatherhead and service mast, meter can, exterior disconnect, the whip and lugs at the AC condenser, then every outdoor receptacle cover on the property. NEC Section 300.6 requires materials suited to the environment they sit in, which near the inlet means stainless hardware, the right enclosure rating, weather-resistant receptacles, and extra-duty in-use covers. A rusted-through mast is not cosmetic: it is what holds the utility drop off your roof, and it is a common reason we hear from the island after a windy night. Our emergency electricians are on call around the clock for exactly that.
Newer Abacoa Homes Run Out of Capacity, Not Time
A 2004 townhome with a 150-amp panel was designed for the appliances of 2004, so work on a house like that starts with a load calculation under NEC Article 220 rather than a guess. An EV charger installation is sized per NEC Article 625, and when the numbers are tight a load-management device or a lower charging amperage often solves it without touching the panel. When it does not, the upgrade buys headroom for the next decade, home battery backup included.
The smaller work is most of an ordinary Tuesday: recessed lighting to replace builder-grade cans, ceiling fan installation on boxes actually rated to carry a fan rather than a light fixture, and smoke and CO detectors, which carry a manufacture date on the back and are meant to be replaced about ten years after it, whatever the test button says.
Pools, Spas, and the Bonding Nobody Sees
Nearly every pool here falls under NEC Article 680, and the piece that causes trouble is the equipotential bonding grid: a solid copper conductor tying the pump motor, shell steel, ladder anchors, and the perimeter surface within three feet of the water into one potential, so nothing in the pool area sits at a different voltage than anything else. It is invisible once the deck is poured, which is why it usually surfaces during a pump replacement or a screen enclosure job. Spas add their own rules, including a disconnect within sight of the tub and set back from the water. Pool and hot tub wiring is one of the few places a shortcut is genuinely dangerous rather than merely non-compliant.
Hurricane Season Load Planning
The time to sort out backup power is winter, not the week a cone appears on the forecast, and there are three honest options. A standby generator installation is the full solution: a permanent unit on its own pad with an automatic transfer switch, running on propane or natural gas, starting itself when the power drops. Expect the fuel side to carry its own permit alongside the electrical one, and expect the set to be anchored for Florida Building Code wind loads rather than simply placed. A generator inlet and interlock is the lower-cost path if you already own a portable unit and want to feed the panel safely instead of running cords under a door. Battery backup covers the quiet, no-fuel case that suits outages measured in hours.
Permits and Inspections: How It Actually Goes Here
- Incorporated Jupiter goes through the Town of Jupiter building department.
- Jupiter Farms and the other unincorporated pockets go through Palm Beach County.
- Tequesta is its own village with its own review.
- Jupiter Inlet Colony applies its own requirements to barrier-island work.
- Jupiter Island sits across the county line in Martin County entirely.
Service and panel changes add a utility step: the meter comes off before the work and goes back on after the inspection passes, so those jobs get scheduled around the utility rather than the other way around. We pull the permit, schedule the inspection, and meet the inspector so you are not taking a day off to do it. Florida Electrical Contractor License EC13015487.
Everything We Bring to a Jupiter Address
- Electrical panel upgrades and service changes
- House rewiring, whole-home and partial
- Electrical safety inspections and four-point report items
- Whole-house surge protection
- Standby generator installation
- Generator inlet and interlock kits
- Home battery backup
- EV charger installation
- Pool and hot tub wiring, including bonding corrections
- Recessed lighting
- Ceiling fan installation
- Smoke and carbon monoxide detectors
- 24/7 emergency electrical service
The full list, commercial work included, is on our services page, and the wider coverage map is on areas we serve.
Our Jupiter Office
Thomas Edison Electric
952 Jupiter Park Lane, Suite 4
Jupiter, FL 33458
Phone: (561) 462-2800
Toll-free: 1-888-705-5600
Office hours: Monday to Friday 7:00 AM to 8:00 PM, Saturday and Sunday 8:00 AM to 3:00 PM
Florida Electrical Contractor License EC13015487
Outside office hours the emergency line is still answered. You can also send us a message or read what neighbors have said on our reviews page.
What Jupiter homeowners say about our work
Jared did a phenomenal job and was able to beat the competition regarding price.
Michael did a fantastic job and was very knowledgeable.
Jupiter Electrician Questions
Which parts of Jupiter do you cover?
All of it: 33458 and 33477 through town and out to the beach, 33478 for Jupiter Farms, and 33469 on the Tequesta and inlet side, plus the towns right around it including Juno Beach, Jupiter Island, and Palm Beach Gardens.
My insurer flagged the panel in my Jupiter house. What happens next?
We open the panel and tell you which items on that report are real defects and which are inspector caution. Some are corrections handled in one visit, such as a double-tapped breaker or a missing bonding jumper. A flagged panel brand is usually a replacement, and we put the scope and the permit path in writing so you have something concrete to hand back to the carrier.
Do you pull the permit, or is that on me?
We do. Permitted work in Jupiter, Jupiter Farms, and the surrounding municipalities is pulled under our Florida electrical contractor license, and we schedule and meet the inspection. On a service or panel change we also coordinate the meter removal and reconnection with the utility so the house is not without power longer than it has to be.
A panel an insurer will not accept, a dock circuit that trips every time it rains, a generator you want in before June: call Thomas Edison Electric at (561) 462-2800 or request a visit online. We are local to Jupiter, and the truck does not have to cross a county to reach you.